Quick Reference Guide

532 IP Source Guard Commands
User Guidelines
The configured IP address and MAC address are used to match the source IP
address and source MAC address for packets received on the interface. Hosts
sending packets using the configured source IP address and source MAC
address are trusted on the interface.
Example
console(config)#ip verify binding 00:11:22:33:44:55 vlan 1 1.2.3.4 interface
gigabitethernet 1/0/2
show ip verify
Use the show ip verify command to display the IP Source Guard
configuration on all interfaces or the specified interface.
Syntax
show ip verify [interface if-id ]
• if-id —A valid interface ID (physical)
Default Configuration
There is no default configuration for this command.
Command Modes
User EXEC, Privileged EXEC (all show modes)
User Guidelines
The filter type is one of the following values:
• ipv4-mac: User has configure MAC address filtering on this interface
• ip: IPv4 address filtering is configured on this interface
• N/A: No filtering is configured on the interface
Example
console(config-if-Gi1/0/5)#show ip verify
Interface Filter Type
2CSNXXX_SWUM200.book Page 532 Tuesday, December 10, 2013 1:22 PM