Quick Reference Guide

Ethernet CFM Commands 419
Default Configuration
No MEPs are preconfigured.
Command Mode
Interface Configuration
User Guidelines
This command has no user guidelines.
Example
The following example creates a maintenance endpoint at level 1 with mpid
1010 on vlan 10.
console(config-if-Gi1/0/3)#ethernet cfm mep level 1 direction up mpid 1010
vlan 10
ethernet cfm mep enable
Use the ethernet cfm mep enable command in Interface Configuration mode
to enable a MEP at the specified level and direction. Use the no form of the
command to disable the MEP.
Syntax
ethernet cfm mep enable level 0-7 vlan 1-4093 mpid 1-8191
• level —Maintenance association level
•
mpid — Maintenance entity identifier
• vlan — VLAN on which the MEP operates.
Default Configuration
No MEPs are preconfigured.
Command Mode
Interface Configuration
User Guidelines
The maintenance domain must exist for it to be enabled.
2CSNXXX_SWUM200.book Page 419 Tuesday, December 10, 2013 1:22 PM