Quick Reference Guide

Ethernet Configuration Commands 409
Default Configuration
No protected switchports are defined.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
This command has no user guidelines.
Example
The following example configures Ethernet port 1/0/1 as a member of
protected group 1.
console(config)#interface gigabitethernet 1/0/1
console(config-if-Gi1/0/1)#switchport protected 1
switchport protected name
Use the switchport protected name command in Global Configuration mode
to adds the port to the protected group 1 and also sets the group name to
"protected".
Syntax
switchport protected groupid name name
no switchport protected groupid name
• groupid — Identifies which group the port is to be protected in.
(Range: 0–2)
•
name — Name of the group. (Range: 0-32 characters)
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
2CSNXXX_SWUM200.book Page 409 Tuesday, December 10, 2013 1:22 PM