Quick Reference Guide

Ethernet Configuration Commands 387
show interfaces configuration
Use the show interfaces configuration command in User EXEC mode to
display the configuration for all configured interfaces.
Syntax
show interfaces configuration [{gigabitethernet unit/slot/port| port-channel
port-channel-number | tengigabitethernet unit/slot/port |
fortygigabitethernet unit/slot/port}]
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode, Configuration mode and all Configuration submodes
User Guidelines
The displayed port configuration information includes the following:
Example
The following example displays the configuration for all configured
interfaces:
console#show interfaces configuration gigabitethernet 1/0/1
Field Description
Port The port number.
Description The port designated IEEE shorthand identifier. For example
1000Base-T refers to 1000 Mbps baseband signaling including both
Tx and Rx transmissions.
Duplex Displays the port Duplex status.
Speed Refers to the port speed.
Neg Describes the Auto-negotiation status.
MTU The Maximum Transmission Unit.
Admin State Displays whether the port is enabled or disabled.
2CSNXXX_SWUM200.book Page 387 Tuesday, December 10, 2013 1:22 PM