Quick Reference Guide

Ethernet Configuration Commands 377
• port-type —Shows all interfaces of the specified type.
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration, Interface Range and Interface modes
User Guidelines
Commands under the interface range context are executed independently on
each active interface in the range. If the command returns an error on one of
the active interfaces, it does not stop executing commands on other active
interfaces.
Example
The following example shows how gigabitethernet ports 5/0/18 to 5/0/20 and
3/0/1 to 3/0/24 are ranged to receive the same command.
console(config)# interface range gigabitethernet 5/0/18-20,3/0/1-24
console(config-if-range)#
The following example shows how all gigabitethernet ports can be configured
at once.
console(config)# interface range gigabitethernet all
console(config-if-range)#
The following examples demonstrate various valid interface ranges:
console(config)#interface range gigabitEthernet 1/0/1-20
console(config)#interface range gi1/0/20-48
console(config)#interface range gi1/0/1,gi1/0/48
console(config)#interface range gi2/0/1-10,gi1/0/30
console(config)#interface range gi1/0/1-10,gi1/0/30-48
console(config)#interface range gi1/0/1,te1/1/1
console(config)#interface range gigabitEthernet 1/0/10,tengigabitEthernet
1/1/2
monitor capture (Global Configuration)
Use the monitor capture command to capture packets transmitted or
received from the CPU. This facility captures switch control plane traffic and
is useful in monitoring network control traffic and analyzing network security.
2CSNXXX_SWUM200.book Page 377 Tuesday, December 10, 2013 1:22 PM