Quick Reference Guide

DHCP Layer 2 Relay Commands 321
Command Mode
Privileged EXEC mode, Configuration mode and all Configuration submodes
User Guidelines
There are no user guidelines for this command.
Example
console#show dhcp l2relay circuit-id vlan 300
DHCP L2 Relay is Enabled.
DHCP Circuit-Id option is enabled on the following VLANs:
300
show dhcp l2relay remote-id vlan
Use the show dhcp l2relay remote-id vlan command in Privileged EXEC
mode to display whether DHCP L2 Relay is globally enabled and shows the
remote ID configured on the specified VLAN or VLAN range.
Syntax
show dhcp l2relay remote-id vlan vlan-range
• vlan-range — Show information for the specified VLAN range. A range may be a
single VLAN ID or two VLAN IDs separated by a single dash with no embedded
spaces.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode, Configuration mode and all Configuration submodes
User Guidelines
There are no user guidelines for this command.
Example
console#show dhcp l2relay remote-id vlan 200
DHCP L2 Relay is Enabled.
VLAN ID Remote Id
2CSNXXX_SWUM200.book Page 321 Tuesday, December 10, 2013 1:22 PM