Quick Reference Guide

Using the CLI 211
Boot Utility Menu
If a user is connected through the serial interface during the boot sequence,
the operator is presented with the option to enter the Boot Utility Menu
during the boot sequence. Selecting item 2 displays the menu and may be
typed only during the initial boot up sequence.
Select startup option within 5 seconds, else Operational Code will start
automatically...
Operational Code Startup -- Main Menu
1 - Start Operational Code
2 - Display Boot Menu
Select (1, 2)# 2
Boot Menu Rev: 6.0
Operational Code -- Boot Main Menu
1 - Start Operational Code
2 - Select Baud Rate
3 - Retrieve Logs
4 - Load New Operational Code
5 - Display Operational Code Details
9 - Reboot
10 - Restore Configuration to Factory Defaults
11 - Activate Backup Image
12 - Start Password Recovery
Enter Choice# 4
Creating tmpfs filesystem on /mnt/download for download...done.
Current Active Image# /dev/mtd7
Which Image to Update Active (/dev/mtd7) OR Back-Up (/dev/mtd6)? Select
(A/B): B
You selected to update Back-Up Image /dev/mtd6...
Select Mode of Transfer (Press T/X/Y/Z for TFTP/XMODEM/YMODEM/ZMODEM) []:T
Please ensure TFTP server is running to begin Transfer...
Enter Server IP []:10.27.9.99
Enter Host IP []:10.27.22.99
Enter Host Subnet Mask [255.255.255.0]:255.255.252.0
Enter Gateway IP []:10.27.20.1
Enter Filename []:jmclendo/N4000v8.21.17.20.stk
Do you want to continue? Press(Y/N): y
2CSNXXX_SWUM200.book Page 211 Tuesday, December 10, 2013 1:22 PM