Quick Reference Guide

1678 System Management Commands
Example 2:
To connect to the stack master (unit 1, below) over a stack member serial
port.
(Unit 2 - CLI unavailable - please connect to master on Unit 1)>connect 1
Stack-Master#
cut-through mode
Use the cut-through mode command to enable the cut-through mode on the
switch. The mode takes effect on all ports on next reload of the switch. To
disable the cut-through mode on the switch, use the no form of this
command.
Syntax
cut-through mode
no cut-through mode
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration
User Guidelines
Cut-through mode is only supported on Dell Networking N4000 series
switches. It is not supported on Dell Networking N2000/N3000 Series
switches.
Example
console(config)#cut-through mode
The mode (enable) is effective from the next reload of Switch/Stack.
exec-banner
Use the exec-banner command to enable exec banner on the console, telnet
or SSH connection. To disable, use the no form of the command.
2CSNXXX_SWUM200.book Page 1678 Tuesday, December 10, 2013 1:22 PM