Quick Reference Guide

SDM Templates Commands 1563
IPv6 Multicast Routes........................512
Now the user sets the next active SDM template for optimal performance for
IPv4 routing.
console# configure
console(config)#sdm prefer ipv4-routing default
Changes to the running SDM preferences have been stored, but cannot take
effect until the next reload.
Use 'show sdm prefer' to see what SDM preference is currently active.
config# show sdm prefer
The current template is the Dual IPv4 and IPv6 template.
ARP Entries..................................6144
IPv4 Unicast Routes..........................8160
IPv6 NDP Entries.............................2560
IPv6 Unicast Routes..........................4096
ECMP Next Hops...............................4
IPv4 Multicast Routes........................1536
IPv6 Multicast Routes........................512
On the next reload, the template will be the IPv4-routing Default template.
To list the scaling parameters for the data center template, invoke the
command with the ipv4-routing data-center keywords.
config# show sdm prefer ipv4-routing data-center
Scaling parameters for the IPv4 data center template:
ARP Entries..................................6144
IPv4 Unicast Routes..........................8160
IPv6 NDP Entries.............................0
IPv6 Unicast Routes..........................0
ECMP Next Hops...............................16
IPv4 Multicast Routes........................2048
IPv6 Multicast Routes........................0
2CSNXXX_SWUM200.book Page 1563 Tuesday, December 10, 2013 1:22 PM