Quick Reference Guide

SDM Templates Commands 1561
Syntax
show sdm prefer {dual-ipv4-and-ipv6 |ipv4-routing} {default|data-center}
• dual-ipv4-and-ipv6 default —List the scaling parameters for the template
supporting IPv4 and IPv6.
•
ipv4-routing default —List the scaling parameters for the IPv4-only
template maximizing the number of unicast routes.
•
ipv4-routing data-center —List the scaling parameters for the IPv4-only
template supporting more ECMP next hops.
•
dual-ipv4-and-ipv6 data-center —List the scaling parameters for the
template supporting IPv4 and IPv6 with higher scale ECMP next hops.
Default Configuration
The default template for the N4000 switch is dual-ipv4-and-ipv6 default . The
default template for the N3000 switch is the
dual-ipv4-and-ipv6 data-center .
The default template for the N2000 is
dual-ipv4-and-ipv6 default . The N2000
has limited routing functionality.
Command Mode
Privileged EXEC, Configuration mode and all Configuration submodes
User Guidelines
When invoked with no optional keywords, this command lists the currently
active template, and the template that will become active on the next reboot,
if it is different from the currently active template. If the system boots with a
non-default template, and you clear the template configuration, either using
the no sdm prefer command or by deleting the startup configuration, the
show sdm prefer command lists the default template as the next active
template. To list the scaling parameters of a specific template, use that
template’s keyword as an argument to the command.
The following table lists the completion messages.
2CSNXXX_SWUM200.book Page 1561 Tuesday, December 10, 2013 1:22 PM