Quick Reference Guide

Virtual Router Redundancy Protocol Commands 1375
Use the no form of this command to remove the interface from the tracked
list or to restore the priority decrement to its default. When removing an
interface from the tracked list, the priority is incremented by the decrement
value if that interface is down.
Syntax
vrrp group track interface vlan vlan-id [decrement priority ]
no vrrp
group track interface vlan vlan-id
• group —The virtual router identifier. (Range: 1-255)
•
vlan vlan-id —Valid VLAN ID.
•
priority —Priority decrement value for the tracked interface. (Range: 1-
254)
Default Configuration
No interfaces are tracked. The default decrement priority is 10.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
This command has no user guidelines.
Example
The following example adds VLAN 2 to the virtual router tracked list (with a
priority decrement value of 20.)
(config-if-vlan10)#vrrp 1 track interface vlan 2 decrement 20
vrrp track ip route
Use the vrrp track ip route command to track the route reachability. When
the tracked route is deleted, the priority of the VRRP router is decremented
by the value specified in the priority argument. When the tracked route is
added, the priority is incremented by the same. A VRRP configured interface
can track more than one route. When a tracked route goes down, the priority
of the router is decreased by 10 (default priority decrement) for each downed
2CSNXXX_SWUM200.book Page 1375 Tuesday, December 10, 2013 1:22 PM