Quick Reference Guide

Tunnel Interface Commands 1361
tunnel source
Use the tunnel source command in Interface Configuration mode to specify
the source transport address of the tunnel, either explicitly or by reference to
an interface.
Syntax
tunnel source { ip-address | interface-type interface-number }
no tunnel source
• ip-address —Valid IPv4 address.
•
interface-type —Valid interface type. VLAN is the only type supported.
•
interface-number —Valid interface number.
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration (Tunnel) mode.
User Guidelines
This command has no user guidelines.
Example
The following example specifies VLAN 11 as the source transport address of
the tunnel.
console(config)#interface tunnel 1
console(config-if-tunnel1)#tunnel source vlan 11
2CSNXXX_SWUM200.book Page 1361 Tuesday, December 10, 2013 1:22 PM