Quick Reference Guide

1328 OSPFv3 Commands
Syntax
show ipv6 ospf neighbor [ interface-type interface-number ] [ neighbor-id ]
• interface-type —Interface type, vlan or tunnel.
•
interface-number —A valid interface number, a valid VLAN ID or tunnel
identifier. (Range is 0-7).
•
neighbor-id —Valid IP address of the neighbor about which information is
displayed.
Default Configuration
This command has no default configuration.
Command Mode
User EXEC, Privileged EXEC mode, Configuration mode and all
Configuration submodes
User Guidelines
This command has no user guidelines.
Examples
The following examples display information about OSPF neighbors, in the
first case in a summary table, and in the second in a table specific to tunnel 1.
console#show ipv6 ospf neighbor
Router ID Priority Intf Interface State Dead
ID Time
--------- -------- ---- ----------- ------------- ----
console#show ipv6 ospf neighbor interface tunnel 1
IP Address..................................... 2.4.6.8
ifIndex........................................ 619
OSPF Admin Mode................................ Enable
OSPF Area ID................................... 0.0.0.0
Router Priority................................ 1
Retransmit Interval............................ 5
Hello Interval................................. 10
Dead Interval.................................. 40
LSA Ack Interval............................... 1
Iftransit Delay Interval....................... 1
Authentication Type............................ None
2CSNXXX_SWUM200.book Page 1328 Tuesday, December 10, 2013 1:22 PM