Quick Reference Guide

IPv6 Multicast Commands 1175
User Guidelines
There are no user guidelines for this command.
Example
console(config)#ipv6 pim rp-address 2001::1 ff1e::/64
ipv6 pim rp-candidate
Use the ipv6 pim rp-candidate command to configure the router to advertise
itself as a PIM candidate rendezvous point (RP) to the bootstrap router
(BSR). Use the no form of this command to disable the router from
advertising itself as a PIM candidate rendezvous point (RP) to the bootstrap
router (BSR).
Syntax
ipv6 pim rp-candidate vlan vlan-id group-address/prefixlength [interval
c_rp_interval ]
no ipv6 pim rp-candidate vlan
vlan-id
• vlan-id—A valid VLAN ID value.
• group-address—The group address to display.
• prefixlength—This parameter specifies the prefix length of the IP address
for the media gateway. (Range: 1–32)
• c_rp_interval—The Candiate RP advertisement interval (range 1-16383
seconds, default 60 seconds).
Default Configuration
The router does not advertise itself as a PIM candidate rendezvous point by
default.
Command Mode
Global Configuration mode
User Guidelines
The default interval for a Candidate Rendezvous Point (C-RP) to send C-RP
Advertisement messages to the Bootstrap Router (BSR) is 60 seconds.
2CSNXXX_SWUM200.book Page 1175 Tuesday, December 10, 2013 1:22 PM