Quick Reference Guide

IPv6 Multicast Commands 1167
52
IPv6 Multicast Commands
Dell Networking N3000/N4000 Series Switches
The Dell Network N2000 series supports limited routing and multicast capabilities.
See the Users Configuration Guide section “Feature Limitations and Platform
Constants” for supported capabilities.
This chapter explains the following commands:
clear ipv6 mroute
This command is used to selectively clear dynamic IPv6 multicast entries
from the cache.
Syntax
clear ipv6 mroute { * | group-address [ source-address ] }
* —Deletes all IPv6 entries from the IP multicast routing table.
group-address — IPv6 address of the multicast group.
source-address —IPv6 address of a multicast srouce that is sending multicast
traffic to the group.
clear ipv6 mroute ipv6 pim rp-address
ipv6 pim (VLAN Interface config) ipv6 pim rp-candidate
ipv6 pim bsr-border ipv6 pim sparse-mode
ipv6 pim bsr-candidate ipv6 pim ssm
ipv6 pim dense-mode show ipv6 pim
ipv6 pim dr-priority ipv6 pim dense-mode
ipv6 pim hello-interval show ipv6 pim interface
ipv6 pim join-prune-interval show ipv6 pim neighbor
ipv6 pim register-threshold show ipv6 pim rp-hash
– show ipv6 pim rp mapping
2CSNXXX_SWUM200.book Page 1167 Tuesday, December 10, 2013 1:22 PM