Quick Reference Guide

Multicast Commands 1157
show ip mroute static
Use the show ip mroute static command in Privileged EXEC mode to display
all the static routes configured in the static mcast table if it is specified or
display the static route associated with the particular
sourceipaddr .
Syntax
show ip mroute static [ sourceipaddr ]
• sourceipaddr — IP address of source.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode, Configuration mode and all Configuration submodes
User Guidelines
This command has no user guidelines.
Example
The following example displays the static routes configured in the static
mcast table.
console#show ip mroute static
MULTICAST STATIC ROUTES
Source IP Source Mask RPF Address Preference
--------------- --------------- --------------- ----------
1.1.1.1 255.255.255.0 2.2.2.2 23
show ip pim
The show ip pim command displays information about the interfaces
enabled for PIM.
Syntax
show ip pim
2CSNXXX_SWUM200.book Page 1157 Tuesday, December 10, 2013 1:22 PM