Quick Reference Guide

1108 IPv6 Routing Commands
Syntax
show ipv6 interface [brief] [loopback loopback-id | tunnel tunnel-id | vlan
vlan-id [prefix]]
• loopback-id —Valid loopback interface ID
•
tunnel-id —Valid tunnel interface ID
•
vlan-id —Valid VLAN ID
•
prefix —Display IPv6 Interface Prefix Information.
Default Configuration
Displays all IPv6 interfaces.
Command Mode
User EXEC, Privileged EXEC modes, Configuration mode and all
Configuration submodes
User Guidelines
The Method field contains one of the following values.
The long form of the command includes the same annotations and shows
whether address autoconfiguration or DHCP client are enabled on the
interface. When the interface acts as a host interface, the output also shows
the default gateway on the interface, if one exists.
Examples
The following example shows the method of assignment for each IPv6 address
that is either autoconfigured or leased from a DHCP server.
console#show ipv6 interface
Field Description
Auto The IPv6 address is automatically generated using IPv6 auto
address configuration (RFC 2462).
Config The IPv6 address is manually configured.
DHCP The IPv6 address is leased from a DHCP server.
TENT Tentative address.
2CSNXXX_SWUM200.book Page 1108 Tuesday, December 10, 2013 1:22 PM