Manualshelf

Quick Reference Guide

ManualsBrandsDell ManualsserversDell Networking N4000 Series
1101110211031104110511061107110811091110
1102 IPv6 Routing Commands
Syntax
ipv6 unicast-routing
no ipv6 unicast-routing
Default Configuration
Disabled is the default configuration.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example globally enables Ipv6 unicast datagram forwarding.
console(config)#ipv6 unicast-routing
console(config)#no ipv6 unicast-routing
ping ipv6
Use ping ipv6 command in Privileged EXEC mode to determine whether
another computer is reachable on the network. The target device must have
the ping responses enabled.
Syntax
ping ipv6 {
ipv6-address
|
hostname
} [repeat
1-15
] | [timeout
1-60
] | [size
0-
13000
] | [source {
ipv6-address
| | loopback
0-7
| vlan
0-4093
| tunnel
0-7
|
out-of-band}]
•
ipv6-address
|
hostname
—The target IP address or host to ping.
• repeat—The number of ping packets to send. Range 1-15.
• timeout—The period in seconds to wait for an ICMP echo reply.
• size—The packet size padding in bytes. Range 0-13000
2CSNXXX_SWUM200.book Page 1102 Tuesday, December 10, 2013 1:22 PM