Quick Reference Guide

IPv6 Routing Commands 1081
49
IPv6 Routing Commands
Dell Networking N2000/N3000/N4000 Series Switches
The Dell Network N2000 series supports limited routing and multicast capabilities.
See the Users Configuration Guide section “Feature Limitations and Platform
Constants” for supported capabilities.
The IPv6 version of the routing table manager provides a repository for IPv6
routes learned by dynamic routing protocols or static configuration. RTO6
manages dynamic and static IPv6 routes, redistributes routes to registered
protocols, supports ECMP routes, and supports multiple routes to the same
destination, sorted by preference. IPv6 routing only operates over VLAN
interfaces.
IPv6 Limitations & Restrictions
The following limitations apply:
• IPSec support is not available.
• The DHCPv6 server does not support stateful address configuration.
• Automated router renumbering is not supported.
Commands in this Chapter
This chapter explains the following commands:
clear ipv6 neighbors ipv6 mld query-
max-response-time
ipv6 route distance show ipv6 mld host-
proxy groups
clear ipv6 statistics ipv6 nd dad
attempts
ipv6 unicast-
routing
show ipv6 mld host-
proxy groups detail
ipv6 address ipv6 nd managed-
config-flag
ping ipv6 show ipv6 mld host-
proxy interface
ipv6 enable ipv6 nd ns-interval ping ipv6 interface show ipv6 mld traffic
ipv6 hop-limit ipv6 nd other-
config-flag
rate-limit cpu show ipv6 neighbors
2CSNXXX_SWUM200.book Page 1081 Tuesday, December 10, 2013 1:22 PM