Quick Reference Guide

1064 IP Routing Commands
Maximum Next Hops.......................... 2
show ip interface
Use the show ip interface command in Privileged EXEC mode to display
information about one or more IP interfaces. The output shows how each IP
address was assigned.
Syntax
show ip interface [ type number ]
• type —Interface type (loopback, out-of-band, or vlan)
•
number —Interface number. Valid only for loopback and VLAN types.
Default Configuration
This command has no default configuration.
Command Mode
User EXEC, Privileged EXEC modes, Configuration mode and all
Configuration submodes
User Guidelines
The Method field contains one of the following values.
Example
console(config-if)#show ip interface
Default Gateway................................ 0.0.0.0
L3 MAC Address..........................
Routing Interfaces:
Interface State IP Address IP Mask Method
---------- ----- --------------- --------------- -------
Field Description
DHCP The address is leased from a DHCP server.
Manual The address is manually configured.
2CSNXXX_SWUM200.book Page 1064 Tuesday, December 10, 2013 1:22 PM