Quick Reference Guide

1014 IGMP Commands
ip igmp startup-query-count
Use the ip igmp startup-query-count command in Interface VLAN
Configuration mode to set the number of queries sent out on startup
—at
intervals equal to the startup query interval for the interface.
Syntax
ip igmp startup-query-count count
no ip igmp startup-query-count
• count — The number of startup queries. (Range: 1-20)
Default Configuration
The default count value is 2.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
This command has no user guidelines.
Example
The following example sets for VLAN 15 the number of queries sent out on
startup at 10.
console(config)#interface vlan 15
console(config-if-vlan15)#ip igmp startup-query-count 10
ip igmp startup-query-interval
Use the ip igmp startup-query-interval command in Interface Configuration
mode to set the interval between general queries sent at startup on the
interface.
Syntax
ip igmp startup-query-interval seconds
no ip igmp startup-query-interval
2CSNXXX_SWUM200.book Page 1014 Tuesday, December 10, 2013 1:22 PM