User Manual

DC-In Port

Removing the DC-in port

1 Follow the procedure in Before working inside your computer.

2 Remove the:

a base cover

b Removing the WLAN card

c Removing the WWAN card

d display assembly

3 To remove the DC-in port:

a Disconnect the DC-in cable from its connector on the system board [1].

b Unroute the DC-in cable from the routing clip on the system [2].

c Remove the M2.5x3 screw that secures the DC-in port to the palmrest [3].

d Lift the DC-in port from the system [4].

Installing the DC-in port

1 Place the DC-in port in its place on the palmrest.

2 Replace the M2x3 screw to secure the DC-in port to the palmrest.

3 Route the DC-in cable through the clip on the system.

4 Connect the DC-in cable to the connector on the system board.

5 Install the:

Removing and installing components