User Manual

3 Ax the adhesive tape to secure the touchpad to the system.

4 Align and place the metal bracket under the plastic hold down.

5 Replace the two M2x2 screws to secure the metal bracket to the touchpad.

6 Install the:

a battery

b base cover

7 Follow the procedure in After working inside your computer.

Display assembly

Removing the display assembly

1 Follow the procedure in Before working inside your computer.

2 Remove the:

a base cover

b battery

c Removing the WLAN card

d Removing the WWAN card

3 Remove the eDP cable from its connector on the system board [1] and unroute the cable from the routing channel on the system fan

[2].

4 Peel o the adhesive tape securing the eDP cable to the system [3].

5 Unroute the eDP cable from the hook of the right LCD hinge and routing clips on the system [4].

6 Unroute the WLAN cables from the routing channel [5] .

7 Then, open the palm-rest assembly to at least 90-degrees and place the system on the edge of a table so that the palm rest is laying

at on the table and the display assembly is over the edge.

Removing and installing components