User Manual

Installing base cover

1 Align the base cover with the screw holders on the computer.

2 Press the edges of the cover until it clicks into place.

3 Tighten the 10 M2.5 screws to secure the base cover to the computer.

4 Install the SIM tray (WWAN models).

5 Follow the procedure in After working inside your computer

Battery

Removing the battery

1 Follow the procedure in Before working inside your computer.

2 Remove the:

a base cover

3 To remove the battery:

a Disconnect the battery cable from the connector on the system board .

b Remove the 5 M2.0x3.0 screws that secure the battery to the computer [1].

NOTE

: For systems shipped with 3-cell battery, you will have to remove only 3 screws.

c Lift the battery away from the computer [2].

Removing and installing components