Service Manual

Installation Guide 17
a Download the latest network drivers from the Drivers and Downloads
section at
support.dell.com .
b Browse for the relevant model of the compute nodes and select
Windows Server 2008 R2 as the operating system.
c Download the relevant Broadcom driver and the corresponding Dell
driver if the compute nodes have PowerEdge Expandable RAID
Controller (PERC) S100 or PERC S300 adapters to the head node.
d On the head node, run the downloaded driver package
Bcom_LAN_14.X.X_W2K3_8_64_AXX.exe and extract the contents
to the default location
C:\Broadcom .
e Click Start  Run and type
C:\Broadcom\Driver_Management_Apps_Installer\s
etup.exe -a
.
This command extracts the additional plug and play (PnP) device
drivers required by some of the models.
f In the InstallShield Wizard , click Next and type C:\Broadcom as
the network location. Click
Install .
g Click Finish and close the installer.
h In the HPC Cluster Manager , click Images in the Configurations pane.
i Click Manage Drivers (all images) on the right side of the window in
the
Image Actions panel.
j In the Manage Drivers window, click Add… and browse to
C:\Broadcom\NX2_W2K3_8_64_RIS_Drivers\b06nd51.
k Select b06nd.inf and click Open . This file adds the drivers needed for
network installation into the compute node pre-install environment.
6 Use the Add button to add the following driver files to the image:
•Evnd51.inf under the location
C:\Broadcom\NX2_W2K3_8_64_RIS_Drivers\evnd51
• Bxdiag.inf under the location C:\Broadcom\Program Files 64\
Broadcom\BDrv5706\DIAG
• Evbd.inf under the location C:\Broadcom\Program Files 64\
Broadcom\BDrv5706\EVBD
book.book Page 17 Monday, September 20, 2010 1:36 PM