Service Manual

Installation Guide 15
On a non-factory installed head node perform the following steps in the
HPC Cluster Manager:
1
Configure Network task in the To-do list :
a Click Configure your network .
b In the Network Topology Selection window, select the Network
Topology of the cluster, for example:
Compute nodes isolated on
a private network
, and click Next .
c In the Enterprise Network Adapter Selection window, select the
NIC that acts as the public network adapter and click
Next .
d In the Private Network Adapter Selection window, select the NIC that
functions as the cluster interconnect and click
Next .
e In the Private Network Configuration window, the default IP address,
and the DHCP scope are displayed. Make modifications if necessary
and click
Next .
f In the Firewall Setup window, configure the firewall settings
(default is recommended) and click
Next .
g In the Review window, verify the contents and click Configure .
h In the Configuration Summary window, click Finish .
2 Provide installation credentials task in the To-do list :
a Click Provide installation credentials.
b Enter the domain administrator user name and password and
click
OK .
3 Configure the naming of new nodes task in the To-do list :
a Click Configure the naming of new nodes .
b Enter the required compute node name and numbering format
(for example:
Compute%001% ). Click OK .
4 Create a Node template task in the To-do list :
a Click Create a Node Template .
b In the Choose Node Template , select compute node template and
click
Next .
book.book Page 15 Monday, September 20, 2010 1:36 PM