Owner's Manual
Deployment Guide 31
7
On the
System Configuration Check
page, the system is scanned for conditions that may block setup.
Make sure all the requirements are met successfully. To proceed with setup after the scan completes,
click
Next
.
8
On the
Registration Information
page, enter information in the
Name
and
Company
text boxes,
enter your 25-character product key and click
Next
.
9
On the
Components to Install
page, select the components for your installation. The following
selections provide the minimum installation of SQL Server 2005 on a single node. Other selections
may be optionally installed once the minimum requirement is complete.
–
SQL Server Database Services
– In case of cluster, select
Create a SQL Server failover cluster
.
NOTE: For more information about Reporting Services, Analysis Services, Notification Services and Integrations
Services, refer to the SQL Server 2005 Books Online or to www.microsoft.com/sql.
Click
Next
when you have completed your selections.
10
On the
Instance Name
page, select an instance for your installation.
– If this is a new installation select
Default instance
.
– If a default or named instance is already installed, click
Named Instance
and then type a unique
instance name in the space provided.
NOTE: Always use Named Instance for cluster installations.
– Click
Next
.
If this is a non-cluster configuration go to step 16.
11
On cluster configuration type a Virtual server name on the
Virtual Server Name
page, Click
NEXT
.
12
On the
Virtual Server Configuration
page, specify Public network and an available IP address, Click
Add
to add the public IP address, then click
Next
.
13
Select the SQL Server resource group that was previously created in the "Creating a Cluster Resource
Group for SQL Server 2005" on page 28.
Enter the
Data Files
location. This location determines where the master database files will be
installed. A location on a shared disk that is part of the SQL Server Cluster Resource Group should be
selected to ensure that the database can failover between nodes.
NOTE: Unavailable cluster groups will show any group that already has a SQL Server instance. Only one instance
can be installed per Cluster Group.
14
In the
Cluster Node Configuration
page, verify that the failover node appears under
Selected Nodes
.
Click
Next
.
15
On the
Remote Account Information
page, type in the password of the domain account that has
permission rights to run the SQL instance on all cluster nodes.