CLI Guide

connectivity validate-local-com
Validates that the actual connectivity over local-com matches the expected connectivity.
Contexts
All contexts.
Syntax
connectivity validate-local-com
[-c|--cluster] context path
[-e|--show-expected]
[-p|--protocol] communication protocol
[-h|--help]
[--verbose]
Arguments
Optional arguments Description
[-c|--cluster] context-
path
path of the cluster where local-com should be validated.
[-e|--show-expected]
Prints the expected connectivity map instead of comparing it to the actual connectivity.
[-p|--protocol]
communication-protocol
Specifies the protocol used for local-com (Fibre Channel or UDP). If not specified, the
command attempts to determine the protocol based on the local-com ports in the system.
[-h|--help]
Displays command line help.
[--verbose]
Provides more output during command execution. This may not have any effect for some
commands.
Description
Verifies the expected local-com connectivity. This command assembles a list of expected local-com connectivity, compares it
to the actual local-com connectivity, and reports any missing or extra connections. This command verifies only IP- or Fibre
Channel-based local-com connectivity.
Expected connectivity is determined by collecting all ports whose role is local-com and verifying that each port in a port-group
has connectivity to every other port in the same port-group.
When both Fibre Channel and IP ports with role local-com are present, the smaller subset is discarded and the protocol of the
remaining ports is assumed to be the correct protocol.
See also
● connectivity director
● connectivity show
● connectivity validate-be
● connectivity validate-wan-com
● health-check
● validate-system-configuration
94
Commands