CLI Guide

storage-tier -
supporting-device device_EMC-CLARiiON-APM00113700075-VNX_LUN122_1
system-id new_name
volume-type virtual-volume
Set the SPC version to Version 3 on an initiator port:
VPlexcli:/clusters/cluster-1/exports/initiator-ports/test_port_1> set scsi-spc-version 3
To avoid Data Unavailability and host issues, follow the procedure described in the KB
article 'SPC-3 support in VPLEX' to change the SPC version.
SPC-3 must be applied only on the supported Operating Systems that are listed in the KB
article. Continue? (Yes/No)
VPlexcli:/clusters/cluster-1/exports/initiator-ports/test_port_1> ll
Name Value
----------------- ------------------------------------------------------------
node-wwn 0x20000025b505003f
port-wwn 0x200000cc05bb002e
scsi-spc-version 3
suspend-on-detach -
target-ports [P0000000043E00BDD-A0-FC00, P0000000043E00BDD-A0-FC01,
P0000000043F00BDD-B0-FC00, P0000000043F00BDD-B0-FC01]
type default
Set the SPC version to Version 3 on a storage view:
VPlexcli:/clusters/cluster-1/exports/storage-views/test_view_1> set scsi-spc-version 3
To avoid Data Unavailability and host issues, follow the procedure described in the KB
article 'SPC-3 support in VPLEX' to change the SPC version.
SPC-3 must be applied only on the supported Operating Systems that are listed in the KB
article. The new SPC version is applied to all the initiators
in the storage-view. Continue? (Yes/No) Yes
VPlexcli:/clusters/cluster-1/exports/storage-views/test_view_1> ll
Name Value
------------------------
-----------------------------------------------------------------------------------------
---------------
caw-enabled true
controller-tag -
initiators [test_port]
operational-status ok
port-name-enabled-status [P0000000043E00BDD-A0-FC00,true,ok, P0000000043E00BDD-A0-
FC01,true,ok,
P0000000043F00BDD-B0-FC00,true,ok, P0000000043F00BDD-B0-
FC01,true,ok]
ports [P0000000043E00BDD-A0-FC00, P0000000043E00BDD-A0-FC01,
P0000000043F00BDD-B0-FC00,
P0000000043F00BDD-B0-FC01]
scsi-spc-version 3
virtual-volumes [(0,device_C1-
RHEL_XtremIO0547_LUN_00001_1_vol,VPD83T3:6000144000000010f00bddd268733d19,200G)]
write-same-16-enabled true
xcopy-enabled true
See also
● storage-volume claim
● storage-volume unclaim
290
Commands