CLI Guide

this command on the remote
cluster to get the health of the remote cluster's RecoverPoint configuration.
Array Aware:
------------
Cluster Name Provider Address Connectivity Registered Total
Arrays Storage Pool
------------ -------- ------------- ------------ ---------- ------------
Hopkinton dsvea125 10.108.64.125 connected 2 13
Hopkinton dsvea123 10.108.64.123 connected 2 29
Providence dsvea124 10.108.64.124 connected 3 21
Run a full-scan health-check on a metro node Metro:
VPlexcli:/> health-check --full
Configuration (CONF):
Checking VPlexCli connectivity to directors.................... OK
Checking Directors Commission.................................. OK
Checking Directors Communication Status........................ OK
Checking Directors Operation Status............................ OK
Checking ports status.......................................... Error
Checking Call Home............................................. Warning
Checking Connectivity.......................................... OK
Checking COM Port Power Level.................................. OK
Checking Meta Data Backup...................................... Warning
Checking Meta Data Slot Usage.................................. Error
Back End (BE):
Checking Unreachable Storage Volumes........................... OK
Checking Degraded Storage Volumes...............................Error
Checking Unhealthy Virtual Volumes............................. OK
Back end array status.......................................... OK
Validating paths to back end arrays............................ OK
Front End (FE):
Checking Storage Views......................................... OK
Checking Front End Path........................................ OK
Cache:
Checking for sub-pages writes(25% or above of total writes).... OK
Checking Stuck IO.............................................. OK
Consistency Group Health:
Consistency Group Health....................................... OK
WAN Link:
WAN Configuration.............................................. OK
WAN Port Settings.............................................. OK
WAN Port Group Settings........................................ OK
WAN Subnet Settings............................................ OK
WAN Bridged and Routed Settings................................ OK
WAN Ping Remote IPs............................................ OK
Director Health Status:
Checking SSD Hardware.......................................... OK
Checking Director RPMs......................................... OK
Output to /var/log/VPlex/cli/health_check_full_scan.log
Run 2 WAN-only scans:
● The first in (default) high-level mode,
● The second in verbose mode:
VPlexcli:/> health-check --wan
WAN Link:
WAN Configuration.... OK
VPlexcli:/> health-check --wan --verbose
WAN Link:
WAN Configuration.................. OK
Connectivity: full
All port-groups have a status of either ok or warning. com connectivity is
complete through minor configuration errors may still exist (see individual
port-group statuses).
port-group-1: OK
All com links have the expected connectivity: this port-group is operating
correctly.
port-group-0: OK
All com links have the expected connectivity: this port-group is operating
correctly.
212
Commands