User`s guide

79
Web Interface Operation
|
Table 24 describes the attributes in the Access Control Table.
Table 24. Access Control Table
Attribute
Description
Index Index number of the entry in the table.
IP Address Management station's IP address. Empty value denotes entry not configured. The IP
address is either an IPv4 or an IPv6 address.
IPv6 Only select this check box if you entered an IPv6 address.
Mask The mask bits to verify the IPv4 or IPv6 address. Select from 1–32.
Valid Address Range SYSTEM-GENERATED. The valid IP address range is set automatically when the mask
is set.
Description User-defined description string.
Access Type Accepts or rejects the entry. Selections are Accept or Reject.
Configuring SNMP Protocol Settings
To set SNMP protocol settings:
1 From the Network menu, click SNMP Configuration. The SNMP Configuration page displays.
2 Enter configuration values in the SNMP Protocol Settings table (see Table 25).
3 Click Save.
4 This procedure is completed.
Table 25 describes the attributes in the SNMP Protocol Settings table.
Table 25. SNMP Protocol Settings
Attribute
Description
SNMP Status Enable or disable the SNMP connection with the Dell DPI.
SNMP UDP Port Simple Network Management Protocol (SNMP) User Datagram Protocol (UDP) port.
You can configure the SNMP protocol to use a port number other than the standard
SNMP port (161).
SNMP Version Simple Network Management Protocol (SNMP) version. Valid values are SNMPv1 and
SNMPv2.
SNMP Read Community Community name for clients allowed to access with read-only privileges. Limited to 31
characters. The characters appear as asterisks (*).
SNMP Write Community Community name for clients allowed access with read-write privileges. Limited to 31
characters. The characters appear as asterisks (*).