Owner's Manual

17 | P a g e

Resolution: Remove the hosts from the connection profile of the vCenter used

for deployment and create a new connection profile on the target vCenter and

add the host you just added to the target VCenter.

Version Affected: 1.0, 1.0.1, 1.0.1 Update 1, 1.5, 1.5.1

Corrected Problems

The following problems were reported in earlier releases of the Dell Management Plug-In and have been

corrected in this release:

Bug # 2149

Issue 1: Unable to perform a single DUP update using a DUP from

OpenManage

7.0 with the DUP being renamed according to the Agile naming

convention.

Bug # 2152

Issue 2: The inventory did not run on host reboot with an ESX 4.0 U1 server

running OMSA 6.5 A01.

Bug # 2258

Issue 3: Unable to remove associated hosts from a connection profile.

Bug # 2268

Issue 4: The firmware update tasks fail saying "Failed to get update job status

from IDRAC." However, the components are updated successfully.

Bug # 2275

Issue 5: The Repository Update job task stays stuck In Progress saying that the

job scheduler will schedule it at the time specified. Each time a Force Reboot

was used, it consistently reproduced this situation.

Bug # 2288

Issue 6: The deployed hosts were not added to the connection profile.

Bug # TFS 1331

Issue 7: Events are not listed correctly in VCenter 5 when viewed from the host

and datacenter levels. This issue happens if you register the Dell Management

Plug-in version 1.0.1 on VCenter 5 and then upgrade to Dell Management Plug-

in 1.0.1 Update 1. .

Bug # TFS 1283

Issue 8: The VCenter Destination Container browse dialog box sometimes lists

datacenters and clusters more than once.

Bug # TFS 1225

Issue 9: The Dell tab shows wrong installation dates.

Bug #DF484706

Issue 10: If the proxy test failed, try to ping the Web site that you used to test

proxy to make sure the Web site is not down.

Bug #DF484657

Issue 11: When you don’t select an option on the last page of the firmware

update using the Single Firmware Update method, the default behavior is

applied the update on next reboot.

Bug #DF483486

Issue 12: It is possible to save the Events and Alarms settings while the Restore

Default Alarms method is still running. Clicking Restore Default Alarms calls the