Owner's Manual

several places under the All Devices organizational view.
For example:
- Under HA Clusters as the HA Cluster
- In the resource pane as the discovered system when the cluster's
organizational group is selected
- In the resource pane as the discovered system when the Servers
organizational group is selected
[250834] [250857] [253557] [266123]
* Duplicate entries of a server found after running a discovery task
If a server and its associated Dell Remote Access Card (DRAC) are
discovered using SNMP (with or without also using IPMI), two entries
for that server are displayed under the All Devices organizational
view: one entry for the server and one for the DRAC.
[266778]
* Dell Servers are classified as Computer even if IPMI is enabled in
the connection profile.
When discovering Dell servers using only SNMP or WMI, Server
Administrator must be installed and running on the managed system
in order for the system to be classified as a Dell Computer.
Consider this situation:
- If IPMI is used in combination with SNMP or WMI,
- You specify both, the server IP address and baseboard management
controller (BMC) IP address in the discovery task, and
- Target server is not running Server Administrator
two devices will be discovered: a Computer and a Dell Computer.
In this case, the Dell Computer is associated with the BMC IP
address and the Computer is associated with the target server.
[272225]
* Altiris Agent push fails in certain cases when using SNMP+IPMI
or SNMP+WS-MAN to discover a server and its associated iDRAC.
If a server and its DRAC or BMC are discovered using SNMP
and IPMI, or SNMP and WS-MAN the IP address of the DRAC/BMC may
be associated as the primary IP address of the server.
To avoid this situation, it is recommended you discover the DRAC/BMC
in its own discovery task before discovering the server in a
separate discovery task.
[285037, 920]
* When you perform an upgrade from Dell Management Console 1.0 > 1.0.1 > 1.1,
the discovery task may fail and a System Format Exception message
is displayed. If the devices are visible under Manage > All Devices
then you can safely ignore this exception.
[709]
* With latest firmware version 3.1, Dell PowerConnect switch M6348 will
not be discovered as Dell device. As a result, PowerConnect M6348