Owner's Manual

net-snmp-5.1.2-13.el4_7.3.x86_64.rpm
* Purge policy will not purge events required for maintaining the device state.
If you have large number of alerts it could cause latency in the Console.
Work-around: You can clear out the alerts manually in SQL Management Studio by
deleting the alert entries in EC_Alerts table and delete the rulestate file
located under [DMC_INSTALL_DIR]\Altiris Agent\Monitor Agent. However this
will clear all device health until the next device health poll
(default: every 1 hour).
[866, 860, 861]
======================================================================
Monitoring
======================================================================
* Alerts sent from some versions of the PowerVault MD Storage
Management Software for the MD3000 family of devices will not be
associated with the MD device in Dell Management Console.
As a result, OnDemand polling for the MD Array will not be triggered.
An alert will be generated on the next scheduled health polling cycle
if the device state has changed. Reduce the polling interval for the
primary health metric if you require more timely updates.
Changing the interval will also affect other devices.
[271243]
* If Performance monitoring is not working, it may be due to:
- The performance polices are not enabled by default. See the
Dell Management Console User’s Guide or the tutorial video for
details on how to enable these policies.
- Performance policies for Windows require Windows 2003 or greater.
- The server you are attempting to monitor must be classified as a
Dell Computer. This is a licensing restriction of the limited
license.
- For WMI support, the credentials defined in the connection profile
at the time the device was discovered must be valid credentials for
that device. If the credentials are no longer valid for the device,
the device must be re-discovered with the proper credentials.
- The last discovery for the device must have included the WMI
protocol. When a device is discovered, it will only use the latest
connection information to communicate with the device.
[255062]
* If any Group Metric target is changed from the default value to a
custom target, this custom target must also be added to the policy.
Changing this target will also force the group metric report to use
this same target. Data from the old target will no longer be visible
in the report.
[902]
* Under certain circumstances, the custom target may not display properly