Manualshelf

Setup Guide

ManualsBrandsDell ManualsActive System ManagerLifecycle Controller Integration Version 3.3 for Microsoft System Center Configuration Manager
10111213141516171819
Steps
1. Run the Dell_Lifecycle_Controller_Integration_3.3.0_for_Configuration_Manager.exe file from the folder where you have
extracted it.
2. A message is displayed stating that another version of DLCI for Configuration Manager is found; and prompts you to upgrade.
Click Yes to continue.
The Welcome screen is displayed.
3. Click Next.
The license agreement is displayed.
4. Accept the license agreement and click Next.
The Custom Setup screen is displayed.
5. Select one or both the components. Follow the steps provided:
• Installing DLCU and DPS
• Installing DLCU only
• Installing DPS only
NOTE:
• You cannot abort the upgrade process by closing the installation wizard. If you close the installation wizard, the following
message is displayed: Are you sure you want to cancel Dell Lifecycle Controller Integration
installation? The upgrade process continues irrespective of the selection you make on the message box.
Using the Modify option in the installer
The Modify option in the DLCI for Configuration Manager installer, modifies the program features that are installed. This option
enables you to perform the following actions:
• Installing a feature that you did not install earlier
• Removing a feature that you had installed earlier
If you uninstall DLCU in the DLCI server using the Modify option, uninstall DPS and install again.
Installing a feature that you did not install earlier
About this task
To install a feature that you did not install earlier:
Steps
1. Run Dell_Lifecycle_Controller_Integration_3.3.0_for_Configuration_Manager.exe from the folder where you have extracted it.
2. Click Next.
The installer displays three options.
3. Select the Modify option.
The Custom Setup screen is displayed.
4. In Custom Setup, select the feature that you did not install earlier.
5. Click Next.
6. In Ready to Modify the Program, click Install to begin installing the feature.
When the installation process completes, click Finish to exit the installer.
Removing a feature that you had installed earlier
About this task
To remove a feature that you had installed earlier:
17