Users Guide

● Standard disks — These are the basic, non-defined disk type that make up the storage on arrays.
● Hot Spares — These disks provide online redundancy if a RAID disk fails while assigned to a specific array.
● All Remaining Disks — These disks provide an option to define an array without specifying the exact number of disks.
If the controller configuration specifies the number of disks required, an equivalent number of disks are added to the non-RAID
group. If the controller specifies the exact quantity, disks cannot be added or removed from the controller – they can only
be moved from array to array (or the non-RAID group). If the controller specifies a minimum number of disks, you can add or
remove disks, but you cannot remove disks below the lower limit of the controller configuration.
Adding a new disk
To add a new disk to an array, select the array and click Disks > New Disk.
You can choose from the following:
● Single disk
● Multiple disks
● Hot spare (only for the current array)
● Global hot spare (all arrays)
Changing a disk
To change a disk, click on the disk and select Disks > Change Disk.
You can change a disk to:
● Standard disk
● Hot spare (only for the current array)
● Global hot spare (all arrays)
Deleting a disk
To delete a disk, click on the disk and select Disks > Delete Disk.
Importing a profile
This menu item allows you to search for, and import an existing Array Builder profile. The XML profile file must be properly
formatted. If it is not formatted correctly, Configuration Manager automatically modifies the XML file and sends a notification of
the change.
To import an existing Array Builder XML file from another location, click Import a Profile.
Using Dell Lifecycle Controller Integration
33