Manualshelf

Users Guide

ManualsBrandsDell ManualsActive System ManagerLifecycle Controller Integration Version 3.2 for Microsoft System Center Configuration Manager
61626364656667686970
6. If you want to remove any of the adapters from the profile, select the adapter and click Remove.
7. You can also click Add to add an adapter to the profile. For more information, see step 4 in Creating
a NIC or CNA profile.
8. Click Save as profile to save the modified NIC profile.
Configuring adapters
About this task
To configure the adapters:
Steps
1. Select the adapter on the Network Adapter Configuration screen and click Configure.
The Adapter Configuration dialog box is displayed.
2. Select one of the following options:
• Configure adapter settings — to configure the settings.
• Copy settings from adapter — to copy the configuration settings from an adapter that is already
configured.
3. Click Configure.
The Configure Adapter dialog box is displayed.
4. Select the port that you want to configure and click Configure.
5. Select one of the following options:
• Configure port settings — to configure the port settings. Proceed to the next step if you want to
configure the port settings manually.
• Copy settings from port — to copy the port settings from a port that is already configured.
Proceed to step 7 if you are copying the port settings.
6. You need to choose the personalities for each partition on the port, enter bandwidth and configure
settings for each personality. One port can have up to four partitions with one personality assigned
to each partition.
Under Personalities and Settings, select the personality against each partition and set the minimum
and maximum bandwidth. You can select from one of the following options:
• NIC
• iSCSI
• FCoE
NOTE: You can select the personalities only for CNAs and not for NICs.
7. Click Port Settings to configure the NIC and iSCSI parameters. For more information, see
Configuring NIC and iSCSI Parameters.
8. Click OK to save the configurations.
Configuring NIC and iSCSI parameters
About this task
You can configure the NIC and iSCSI parameters from the Port Settings screen.
To configure the NIC and iSCSI parameters:
Steps
1. In the Port Settings screen, on the NIC tab, specify the following parameters:
• Select All — Select to check all the options available for NIC.
69