Users Guide

Issue 13

Issue: Installation fails while installing DLCI for Configuration Manager version 1.3 on Microsoft Windows

2008 32-bit SP2 with the User Account Controller (UAC) option turned on.

Resolution: Turn off UAC and reinstall DLCI for Configuration Manager version 1.3. Alternatively, you can

install DLCI for Configuration Manager using the Command Line Interface (CLI). Before you do so, right-

click the installer, select Properties, click on the Compatibility tab and select the Run as Administrator

option.

Issue 14

Issue: The Deploy option does not appear in an existing task sequence after uninstalling and reinstalling

DLCI for Configuration Manager.

Resolution: Open the task sequence for editing, re-enable the Apply option, and click OK. The Deploy

option appears again.

To re-enable the Apply option:

1. Right-click the task sequence and select Edit.

2. Select Restart in Windows PE. In the Description section, type any character and delete it so the

change is not saved.

3. Click OK.

This re-enables the Apply option.

Issue 15

Issue: The System Viewer Utility does not display the latest RAID configuration.

Resolution: When you are viewing the RAID configuration for a system using the System Viewer Utility,

the information is cached. When you update the RAID configuration of the same system, you must close

the System Viewer Utility and re-open it to view the updated RAID configuration.

Issue 16

Issue: The Modular systems cannot use the hostname in the path to the CIFS share but monolithic

systems can use the hostname.

Resolution: For Modular systems you must specify the IP address of the CIFS share.

Issue 17

Issue: When you are updating the systems with the latest firmware, if the Dell Update Packages (DUPS)

take longer than 50 minutes to download over a WAN, then the update task may fail.

Resolution: If you face this problem, then you must copy the repository that contains the updates to the

local network of the systems you are updating.