Users Guide

NOTE: DLCI for Configuration Manager does not support variables created in an encrypted

format.

Adding a new variable condition

To add a new variable condition:

1. Under an embedded controller, expand Embedded Controller, and select [No variable conditions

defined]

2. Click Variables→ New Variable Condition.

The Variable Condition Configuration window is displayed.

3. Under Variable Matching Criteria, you can set a rule to apply this variable only if it matches certain

criteria that you select.

4. Click OK to apply the variable condition, or Cancel to return to the Array Builder.

Editing a variable condition

To edit a variable condition:

1. Select the variable condition and click Variables→ Edit Variable Condition.

The Variable Condition Configuration window is displayed where you can make changes to your

variable condition.

2. Click OK to apply the variable condition, or Cancel to return to Array Builder.

Deleting a variable condition

To delete a variable condition:

1. Select the variable condition and click Variables→ Delete Variable Condition.

A message that all the attached arrays and disks will be deleted is displayed.

2. Click Yes to delete or No to cancel.

Arrays

Array nodes include both RAID arrays and non-RAID disk groups that are indicated by the different icons

for RAID arrays and non-RAID disks. By default, a non-RAID disk group is created when a controller is

created. If the controller configuration specifies the number of disks required, the same number of disks

is added to the non-RAID group.

Arrays can be added, modified or deleted depending on the controller configuration and number of disks

available.

Array elements contain logical drives and physical disks.

Adding a new array

To add a new array:

1. Under a variable condition, select a variable condition and click Arrays→ New Array.

The Array Settings window is displayed.

2. Set the required RAID level from the Desired RAID Level drop-down menu.

3. On RAID levels 50 and 60, enter the span length of the array.

4. Click OK to apply the array, or Cancel to return to Array Builder.