Users Guide

Configuring RAID
To configure RAID:
1. Click Browse and select the RAID profile that you created using the System Viewer utility. This profile
is applied during the operating system deployment process. For more information on creating RAID
profiles, see
Using the Array Builder.
2. Click Next to configure network adapters.
NOTE: When you configure RAID settings on a system, the original controller settings of the
system are reset and the virtual disks (VDs) that are configured, or any other configuration are
cleared.
Applying a NIC or CNA profile on a collection
NOTE: In Config Utility, if you apply an attribute value, the dependent attribute value is not
checked.
Refer Lifecycle Controller documentation for supported CNAs.
To configure Network Adapters and apply a NIC/CNA profile on a collection:
1. Click Browse and select the NIC/CNA profile that you created using the System Viewer utility. This
profile is applied during the hardware configuration process. For more information on creating
NIC/CNA profiles, see
Creating a NIC or CNA Profile.
2. If you select a simple NIC profile you can validate if all the settings in the profile are applied on the
target system by launching the Unified Server Configurator on the target system.
3. If you select a Broadcom CNA profile, you can validate if the settings are applied based on the Table
3:
Table 3. Broadcom Profile Settings
S.No Target Server Setting Profile Settings What is Applied
1. Dual Port NIC (partition
disabled)
Dual Port NIC
Dual Port Quad Partition
NIC
Dual Port Quad Partition
NIC
Partition is enabled
when the system
reboots.
2. Dual Port NIC (partition
disabled)
Dual Port NIC Dual Port NIC
Port level settings are
applied when the
system reboots.
3. Dual Port NIC (partition
disabled)
Dual Port Quad Partition
NIC
Dual Port Quad Partition
NIC
Partition is enabled
when the system
reboots.
39