Manualshelf

Users Guide

ManualsBrandsDell ManualsActive System ManagerLifecycle Controller Integration Version 3.0 for Microsoft System Center Configuration Manager
11121314151617181920
• Check the permissions on the network share and make sure the share is accessible from the Lifecycle
Controller on the target systems.
Workflow
1. To view the Lifecycle Controller logs of a single target system, launch the System Viewer utility. To
view the Lifecycle Controller logs of a collection of systems, launch the Config Utility. For more
information, see
System Viewer Utility or Configuration Utility.
2. Select View Lifecycle Controller Logs on the System Viewer utility or the Config Utility.
3. For a single system, see Viewing Lifecycle Controller Logs.
4. For a collection, see Viewing and Exporting Lifecycle Controller Logs for a Collection.
Working With NIC or CNA Profiles
You can configure the different attributes of specific network interface cards (NICs) or converged
network adapters (CNAs) embedded in the system and save them to a profile. You can create and edit
NIC or CNA profiles using the System Viewer utility.
Prerequisites
For more information, see Common Prerequisites.
Workflow
1. Launch the System Viewer utility on the ConfigMgr console for a particular system. For more
information, see System Viewer Utility.
2. Select Network Adapter Configuration.
3. Select one of the following options:
• Create a profile — to create a new NIC or CNA profile. For more information, see Creating a NIC
or CNA Profile.
• Edit an existing profile — to edit an existing NIC/CNA profile. For more information, see Editing a
NIC or CNA Profile.
• Scan collection to identify adapters — to scan the collection and list the configured adapters in
the collection. For more information, see Comparing and Updating Firmware Inventory.
4. Add an adapter to the profile or remove an adapter from the profile. For more information, see
step 3–4 in Creating a NIC or CNA Profile.
5. Select the adapter on the grid and configure it. For more information, see Configuring Adapters.
6. Set the NIC and iSCSI parameters for the personalities you have chosen for each partition. For more
information, see
Configuring NIC and iSCSI Parameters.
7. Save the NIC or CNA profile.
17