Users Guide

Workflow

1. To view the Lifecycle Controller logs of a single target system, launch the System Viewer utility. To view the

Lifecycle Controller logs of a collection of systems, launch the Config Utility. For more information, see System

Viewer Utility or Configuration Utility.

2. Select View Lifecycle Controller Logs on the System Viewer utility or the Config Utility.

3. For a single system, see Viewing Lifecycle Controller Logs.

4. For a collection, see Viewing and Exporting Lifecycle Controller Logs for a Collection.

Working With NIC or CNA Profiles

You can configure the different attributes of specific network interface cards (NICs) or converged network adapters

(CNAs) embedded in the system and save them to a profile. You can create and edit NIC or CNA profiles using the

System Viewer utility.

Prerequisites

For more information, see Common Prerequisites.

Workflow

1. Launch the System Viewer utility on the ConfigMgr console for a particular system. For more information, see

System Viewer Utility.

2. Select Network Adapter Configuration.

3. Select one of the following options:

• Create a profile — to create a new NIC or CNA profile. For more information, see Creating a NIC or CNA Profile.

• Edit an existing profile — to edit an existing NIC/CNA profile. For more information, see Editing a NIC or CNA

Profile.

• Scan collection to identify adapters — to scan the collection and list the configured adapters in the collection.

For more information, see Comparing and Updating Firmware Inventory.

4. Add an adapter to the profile or remove an adapter from the profile. For more information, see step 3–4 in Creating a

NIC or CNA Profile.

5. Select the adapter on the grid and configure it. For more information, see Configuring Adapters.

6. Set the NIC and iSCSI parameters for the personalities you have chosen for each partition. For more information,

see Configuring NIC and iSCSI Parameters.

7. Save the NIC or CNA profile.