Users Guide

ManualsBrandsDell ManualsSoftwareDell Lifecycle Controller Integration Version 2.1 for Microsoft System Center Configuration Manager

Table 3. Broadcom Profile Settings

S.No Target Server Setting Profile Settings What is Applied

1. Dual Port NIC (partition

disabled)

Dual Port NIC

Dual Port Quad Partition

NIC

Dual Port Quad Partition

NIC

Partition is enabled when

the system reboots.

2. Dual Port NIC (partition

disabled)

Dual Port NIC Dual Port NIC

Port level settings are

applied when the system

reboots.

3. Dual Port NIC (partition

disabled)

Dual Port Quad Partition

NIC

Dual Port Quad Partition

NIC

Partition is enabled when

the system reboots.

4. Dual Port Quad Partition

NIC

Dual Port NIC

Dual Port Quad Partition

NIC

Dual Port Quad Partition

5. Dual Port Quad Partition

NIC

Dual Port NIC Nothing is applied as there

is no match between the

target server setting and

profile setting.

6. Dual Port Quad Partition

NIC

Dual Port Quad Partition

NIC

Dual Port Quad Partition

4. Click Next to apply an Integrated Dell Remote Access Controller profile.

NOTE: If there is an error while applying a NIC/CNA profile, the operating system deployment process

continues to the next step. While applying an attribute using Config Utility, it does not check the dependent

attributes value. After the Hardware configuration task is complete, use Network Adapter Comparison Report

in Config Utility to check if the attributes have been applied successfully.

Applying an Integrated Dell Remote Access Controller Profile on a Collection

To configure Integrated Dell Remote Access Controller and apply an Integrated Dell Remote Access Controller profile on

a collection:

1. Click Browse and select the Integrated Dell Remote Access Controller profile that you created using the System

Viewer utility. This profile is applied during the hardware configuration process. For more information on creating

Integrated Dell Remote Access Controller profiles, see Creating an Integrated Dell Remote Access Controller

Profile.

2. After you select an Integrated Dell Remote Access Controller profile, you can validate if the configuration is applied

based on the following parameters:

Table 4. iDRAC Profile Settings

S.No Target Server Profile Settings What is Applicable

1. Rack and Tower systems All four types of attributes

are configured.

All attributes in the

Integrated Dell Remote

Access Controller profile.

2. Blade systems All four types of attributes

are configured.

• All attributes in

Common IP settings.