Users Guide

Property Options

– Apply only if firmware matches: Select this

option to apply the current configuration only if

the current firmware matches with the

firmware of the replaced part.

– Do Not Change: Select this option to leave the

default settings as is. This is selected by

default.

4. Click Finish after selecting the required options.

The following message is displayed: Task submission complete.

A task is submitted to the Task Viewer. You can launch the Task Viewer to view the status of the task. The task

configures the Lifecycle Controller of the system with the Part Replacement configuration. This configuration takes

effect when you replace any part for the system.

If you have updated the Part Replacement Attributes, sometimes the updates are not set immediately. Wait for

couple of minutes and check to see if the updates are set.