Owner's Manual

88 Using The System Viewer Utility
5 You need to choose the personalities for each partition on the port, enter
bandwidth and configure settings for each personality. One port can have
up to four partitions with one personality assigned to each partition.
Under
Personalities and Settings , select the personality against each
partition and set the minimum and maximum bandwidth. You can select
from one of the following options:
–NIC
– iSCSI
–FCoE
NOTE: You can select the personalities only for CNAs and not for NICs.
6 Click Port Settings to configure the NIC and iSCSI parameters. For more
information, see Configuring NIC And iSCSI Parameters.
7 Click OK to save the configurations.
Configuring NIC And iSCSI Parameters
You can configure the NIC and iSCSI parameters from the Port Settings
screen.
To configure the NIC and iSCSI parameters:
1
In the Port Settings screen, on the NIC tab, specify the following
parameters:
– Select All — Select this to check all the options available for NIC.
–
Boot Protocol — Select the protocol for booting the system. You can
choose from
PXE , iSCSI , iSCSIPrimary, iSCSISecondary , iBFT ,
BootP , FCoE, or NONE .
–
Wake on LAN — Allows you to switch on the system throughout your
LAN. You can choose to enable or disable this option.
–
Wake on LAN link speed — Specify the Wake on LAN link speed
from the drop-down list.
–
VLAN mode — Allows you to add your system to a VLAN if it is not
located on the same network switch. You can choose to enable or
disable this option.
–
Link speed — Specify the NIC link speed by selecting from the drop-
down list.
DLCI_UserGuide.book Page 88 Friday, October 12, 2012 7:16 PM