Owner's Manual

82 Using The System Viewer Utility
5 Enter the values of the attributes based on the type of attribute that you
select. Let us assume that you have selected the attribute type
Enum
Attribute
.
– To add a value, enter the value of the enumeration attribute in the
Possible Value field, and click Add .
– To update the value of the attribute, select the value that you want to
update, make the necessary changes in the
Possible Values field, and
click
Update .
– To delete a value, select the value and click
Delete . A dialog box
appears asking for confirmation. Click
Yes to delete the value.
6 Click OK to close the Custom Attribute Editor and go back to the BIOS
Attributes
tab.
Editing An Existing BIOS Attribute
To edit an existing BIOS attribute, see step 2 to step 5 of Editing An Existing
Profile
.
Changing The BIOS Boot Sequence And Hard-Disk Drive Sequence
To change the BIOS boot sequence and hard-disk drive sequence:
1
In the BIOS Configuration screen, select Create a New Profile or Edit an
Existing Profile
, and click Browse to browse for the profile.
2 Click on the Boot Sequence tab.
The current BIOS boot sequence and hard-disk drive sequence is
displayed.
3 Use the Move Up and Move Down buttons to change the BIOS boot
sequence or the hard disk drive sequence.
4 Click OK to save the changes.
NOTE: Click Reset to reset any changes made.
DLCI_UserGuide.book Page 82 Friday, October 12, 2012 7:16 PM