Owner's Manual

64 Using The Configuration Utility
– Hardware — displays the hardware components of the system. For
example, memory, CPU, iDRAC card, and so on.
–
FQDD — displays the fully qualified device description of the
hardware component.
–
Description — displays the properties of the hardware component.
NOTE: When the Config Utility is fetching the hardware inventory details of the
collection, and there is a disruption in the network connectivity, close the utility
and launch it again when the network connectivity is restored. The hardware
inventory details do not get refreshed automatically.
NOTE: For the yx1x systems, the Slot Length and Slot Type fields may show the
status as Not Applicable instead of Unknown.
Verifying Communication With Lifecycle
Controller
Use the following steps to verify the credentials of the discovered systems
with iDRAC:
1
From the Configuration Manager console, do the following:
• In Configuration Manager 2007, under
Computer Management 
Collections
.
• In Configuration Manager 2012, under
Devices .
2 Right-click on All Dell Lifecycle Controller Servers and select Dell
Lifecycle Controller
 Launch Config Utility .
3 On the Dell Lifecycle Controller Configuration Utility window, select
Session Credentials, Verify Communication .
4 Click Run Check to verify communication with the iDRACs of the
discovered systems. A list of iDRACs discovered on the network appears
along with their communication status.
5 Once the check is complete, click Export to csv to export the results in
CSV format. Provide the location on your local drive.
or
Click
Copy to Clipboard to copy the results to the clipboard and save it in
plain text format.
DLCI_UserGuide.book Page 64 Friday, October 12, 2012 7:16 PM