Owner's Manual

58 Using The Configuration Utility
1 Click Browse and select the RAID profile that you created using the
System Viewer utility. This profile is applied during the operating system
deployment process. For more information on creating RAID profiles using
the
System Viewer utility, see Using The Array Builder.
2 Click Next to configure network adapters.
NOTE: When you configure RAID settings on a system, the original controller
settings of the system are reset and the virtual disks (VDs) that are configured,
or any other configuration are cleared.
Applying NIC/CNA Profile On A Collection
NOTE: In Config Utility, if you apply an attribute value, the values of the dependent
attributes are not checked.
See the Lifecycle Controller documentation for supported CNAs.
To configure network adapters and apply a NIC or CNA profile on a
collection:
1
Click Browse and select the NIC/CNA profile that you created using the
System Viewer utility. This profile is applied during the hardware
configuration process. For more information on creating NIC or CNA
profiles, see Creating A NIC Or CNA Profile.
2 If you select a simple NIC profile, you can validate if all the settings in the
profile are applied on the target system by launching the Unified Server
Configurator on the target system.
3 If you select a Broadcom CNA profile, you can validate if the settings are
applied based on Table 4-1:
Table 4-1. Broadcom Profile Settings
S.No Target Server Setting Profile Settings What Is Applied
1. Dual Port NIC
(partition disabled)
Dual Port NIC
Dual Port Quad Partition
NIC
Dual Port Quad Partition
NIC
Partition is enabled when
the system reboots.
DLCI_UserGuide.book Page 58 Friday, October 12, 2012 7:16 PM