Owner's Manual

46 Using Dell Lifecycle Controller Integration
2 Click OK to apply the changes, or Cancel to return to Array Builder .
Deleting An Array
1 Select the array and click Arrays  Delete Array . A message is displayed
that all the attached disks will be deleted.
2 Click Yes to delete or No to cancel.
Logical Drives (Virtual Disks)
You can have logical drives on RAID arrays and non-RAID groups. You can
configure them by specifying the size (in GB) or consume all available (or
remaining) space in the array. By default, a single logical drive is created for all
new arrays and is set to use all the available space.
When specific-size logical drives are defined, the using all remaining space
logical drive will consume any remaining space after other logical drive(s)
have allocated their space on the array.
NOTE: Array Builder does not support creating logical drives of sizes 10, 50,
and 60 GB, and does not support creating logical drives under Non-RAID groups.
Adding A New Logical Drive
1 Select the array and click Logical Drives  New Logical Drive . The
Logical Drive Settings window is displayed.
2 Under Create a logical drive enter the exact number of gigabytes the
logical drive must contain.
3 Click OK to create the logical drive, or click Cancel to return to Array
Builder
.
DLCI_UserGuide.book Page 46 Friday, October 12, 2012 7:16 PM