Owner's Manual

Using Dell Lifecycle Controller Integration 45
Editing A Variable Condition
1 Select the variable condition and click Var iabl es  Edit Variable
Condition
. The Variable Condition Configuration window is displayed
where you can make changes to your variable condition.
2 Click OK to apply the variable condition, or Cancel to return to Array
Builder
.
Deleting a Variable Condition
1 Select the variable condition and click Var iabl es  Delete Variable
Condition
. A message is displayed that all the attached arrays and disks
will be deleted.
2 Click Yes to delete or No to cancel.
Arrays
Array nodes include both RAID arrays and non-RAID disk groups that are
indicated by the different icons. By default, a non-RAID disk group is created
when a controller is created. If the controller configuration specifies the
number of disks required, the same number of disks is added to the non-
RAID group.
Arrays can be added, modified, or deleted depending on the controller
configuration and number of disks available.
Array elements contain logical drives and physical disks.
Adding A New Array
1 Under a variable condition, select a variable condition and click Arrays 
New Array . The Array Settings window is displayed.
2 Set the required RAID level from the Desired RAID Level drop-down list.
If you are setting RAID levels 50 and 60, then enter the span length of the
array.
3 Click OK to apply the array, or Cancel to return to Array Builder .
Editing An Array
1 Select the array and click Arrays  Edit Array . The Array Settings window
is displayed. You can edit the array by selecting a different RAID level for
the array.
DLCI_UserGuide.book Page 45 Friday, October 12, 2012 7:16 PM